Raymarine a Series Installation And Operation Instructions Manual page 89

12. Insert the MicroSD card into the card reader of your
multifunction display.
After a few seconds your multifunction display will alert you
that a software update is available and which multifunction
displays and remote keypads require the update.
The software alert is only displayed once per power cycle.
13. Select Yes to begin the software update.
The following steps will now take place:
1. All networked multifunction displays will reboot and
commence a simultaneous software update (During the
software update the display with the software update
memory card inserted will display a progress indicator.
2. Once the networked displays have been updated the
display containing the software update memory card will
reboot and commence the software update.
3. Once all displays have been updated the system will
check to see if any connected remote keypads require a
software update.
14. If you have a remote keypad connected then select Yes to
update the keypad software update.
When the software update process has been completed a
confirmation pop-up is displayed.
15. Select OK to confirm.
16. Remove the MicroSD card from the card reader.
17. Perform a factory reset of your multifunction displays
following the procedure described in section
your system.
18. Restore any saved user data and settings by following the
procedure described in section
user settings
Note: Turning on a display whilst it has a software update
memory card inserted will start a standalone software update
on that display only.
Getting started
8.6 Resetting
8.4 Saving user data and
87