Raymarine a Series Installation And Operation Instructions Manual page 178

Cartography objects
If supported by you cartography type, cartographic objects can be individually switched on and off. The table below show a
list of these objects.
The Objects menu is accessed from: Menu > Presentation > Objects.
Note: The Objects menu is only available when the cartography in use supports these features.
Object (Menu item)
Show Rocks
Nav. Marks
Nav. Mark Symbols
Light Sectors
Routing Systems
Caution Areas
Marine Features
Land Features
Business Services
Panoramic Photos
Roads
Additional Wrecks
Colored Seabed Areas
176
Description
Determines the depth at which rocks are displayed in the
chart application.
Determines whether navigation marks are displayed on
the chart:
• Off — navigation marks are NOT displayed.
• On — navigation marks are displayed.
Determines which set of navigation mark symbols is used
— International, or US. These symbols correspond to
paper charts.
Determines whether the sector of light cast by a fixed
beacon is displayed or not.
• Off — sector of light is NOT displayed.
• On — sector of light is displayed.
Determines whether routing data is displayed or not.
• Off — routing data is NOT displayed.
• On — routing data is displayed.
Determines whether caution data is displayed or not.
• Off — caution data is NOT displayed.
• On — caution data is displayed.
When this menu item is set to On, the following
water-based cartographic features are displayed:
• Cables.
• Nature of seabed points.
• Tide stations.
• Current stations.
• Port information.
When this menu item is set to On, land-based cartographic
features are displayed.
When this menu item is set to On, symbols indicating the
location of a business will be shown.
Determines whether panoramic photos are available for
landmarks such as ports and marinas.
Determines whether major coastal roads are displayed
on the chart:
• Off — coastal roads are NOT displayed.
• On — coastal roads are displayed.
Determines whether extended information for new wrecks
is displayed.
Provides greater definition of the seabed. This applies
only to limited areas where the extra detail is available.
Options
• 0–6 ft / 0–2 m / 0–1 fa
• 0–18 ft / 0–5 m / 0–3 fa
• 0–30 ft / 0–10 m/ 0–5 fa
• 0–50 ft / 0–15 m / 0–8 fa
• 0–60 ft / 0–20 m / 0–10 fa
• All (default)
• Off
• On (default)
• International (default)
• US
• Off
• On (default)
• Off
• On (default)
• OFF
• ON (default)
• Off
• On (default)
• Off
• On (default)
• Off
• On (default)
• Off
• On (default)
• Off
• On (default)
• Off
• On (default)
• Off (default)
• On
a Series / c Series / e Series