Mounting - New C Series And New E Series - Raymarine a Series Installation And Operation Instructions Manual

display, ensuring that the clips along the bottom edge of the
bezel latch into position.
4. Ensure the bezel is correctly aligned with the display, as
shown.
5. Apply firm but even pressure to the bezel along the:
i. Outer edges - work from the sides upwards and then
along the top edge, to ensure that it clips securely into
position.
ii. Inner edges - particularly along the chart card door edge,
to ensure that the bezel sits flat.
6. Check that the Power button and chart card door are free
to operate.
Removing the front bezel
Before proceeding ensure the memory card slot door is open.
2 2 2 2
1 1
1 1 1 1
Important: Use care when removing the bezel. Do not use
any tools to lever the bezel; doing so may cause damage.
1. Place both your thumbs on the upper left edge of the display,
at the positions indicated in the diagram above.
2. Place your fingers underneath the bezel, at the positions
indicated in the diagram above.
3. In a single firm motion, apply pressure to the outer edge of
the display with your thumbs and pull the bezel towards you
using your fingers.
The bezel should now come away from the display easily.
Mounting
D12586-1
2 2 2 2
D12584-1
5.2 Mounting - New c Series and New
e series
Removing the rear bezel
You must remove the rear bezel before surface mounting the
display.
Note: These steps do not apply to the e165 as it does not
require a rear bezel.
1. Remove the front bezel. Refer to the separate instructions
provided for that procedure.
1
2
2. Remove the screws that secure the bezel to the display (only
required for e7 and e7D).
3. Carefully remove the bezel from the rear of the display,
pulling the bezel gently along the:
i. Outer edges - work from the sides upwards and then
along the top edge, ensuring that the clips are fully
released from the display.
ii. Inner edges - ensure that the bezel is completely removed
from the display.
Note: Only the e7 and e7D have fixing screws for the rear
bezel, other multifunction display variants have clips which
hold the rear bezel in place.
Surface mounting
The display can be surface mounted.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will
take.
• Detached the front bezel.
3
D12184-3
65