Raymarine a Series Installation And Operation Instructions Manual page 46

Network connection
1. Network switch.
2. Keypad.
3. Right angled power cable.
4. Networked multifunction displays.
When connecting the keypad via a network switch the keypad
must be powered separately, using the alternate power
connector.
Once connected the keypad must be paired with the each
multifunction display you want to control using the keypad.
Radar connection
The multifunction display is compatible with Raymarine Non-HD
digital radomes and HD / SuperHD radar scanners. The scanner
is connected using over SeaTalk
Note:
• New c Series and New e Series displays (excluding the
e7 and e7D) can connect 2 SeaTalk
directly to the display.
• New a Series and the e7 / e7D displays can connect 1
SeaTalk hs / RayNet device directly to the display.
The radar is usually connected via a Raymarine network switch.
On smaller systems (with only one display and no other digital
devices) the radar may be connected to the display directly.
44
1 2
4
hs .
hs / RayNet devices
Radar connected using Raymarine network switch
3
1
D12697-3
1. Radar scanner.
2. Raymarine network switch.
3. RayNet cable.
4. RayNet radar cable.
5. VCM (Voltage Converter Module) — required for Open
Arrays.
6. Power connection.
Radar connected directly to the display
1. Radar scanner
2. Multifunction display rear connector panel.
3. RayNet Radar cable.
4. Connection to power supply — Open array scanners
require a VCM (Voltage Converter Module).
6 5
1
D12253-2
a Series / c Series / e Series