Pnp/Pci Configurations - MSI MS-9125 User Manual

MS-9125 SSI Mainboard

PNP/PCI Configurations

This section describes configuring the PCI bus system and PnP (Plug &
Play) feature. PCI, or Peripheral Component Interconnect, is a system which
allows I/O devices to operate at speeds nearing the speed the CPU itself uses
when communicating with its special components. This section covers some
very technical items and it is strongly recommended that only experienced
users should make any changes to the default settings.
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended
System Configuration Data (ESCD) when you exit Setup if you have installed
a new add-on card and the system reconfiguration has caused such a serious
conflict that the operating system cannot boot. Setting options: Enabled,
Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure
all of the boot and Plug and Play compatible devices. However, this capability
means absolutely nothing unless you are using a Plug and Play operating sys-
®
tem such as Windows 95/98. If you set this field to "manual" choose specific
resources by going into each of the sub menu that follows this field (a sub
menu is preceded by a " "). The settings are: Auto (ESCD), Manual.
3-26