MSI MS-9125 User Manual page 68

MS-9125 SSI Mainboard
the field for the PS/2 keyboard to power on the system. Please note that
this function will only work under S3 mode.
Hot Key Power ON
If POWER ON Function is set to Hot KEY, you can assign a hot key com-
bination in the field for the PS/2 keyboard to power on the system. Settings:
Ctrl-F1 through Ctrl-F12. Please note that this function will only work
under S3 mode.
Onboard FDC Controller
The item is used to enable or disable the onboard Floppy controller. Se-
lect Enabled when you have installed a floppy disk drive and want to use
it.
Onboard Serial Port 1/2
The items specify the base I/O port address and IRQ for the onboard Serial
Port 1 (COM 1)/Serial Port 2 (COM 2). Selecting Auto allows BIOS to
automatically determine the correct base I/O port address. Settings:
Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power fail-
ure or interrupts occurs. Available settings are:
Off Leaves the computer in the power off state.
On Reboots the computer.
Former-Sts Restores the system to the status before power failure or
interrupt occurs.
3-22