Table of Contents
Advertisement
MS-9125 SSI Mainboard
ATA100 Connector: PRI IDE
The mainboard offers one Ultra ATA/100 hard drive connector.
ATA133 RAID Connectors: RAID IDE1, RAID IDE2
The mainboard supports high-end Ultra ATA/133 RAID (0, 1, or 0+1)
hard drive interface specifications as well.
The Ultra ATA/133 interface boosts data transfer rates between the com-
puter and the hard drive up to 133 megabytes (MB) per second. The new
interface is one-third faster than earlier record-breaking Ultra ATA/100 tech-
nology and is backwards-compatible with the existing Ultra ATA interface.
The low-cost RAID (Redundant Array of Independent Disks) solution
integrates two IDE RAID connectors that support PIO mode 0-4, Bus Master,
and Ultra DMA 33/66/100/133 modes. The IDE RAID connectors allow you
to connect Ultra ATA/DMA hard disks and use RAID technology (RAID 0
striping or RAID 1 mirroring) for high performance, data security and fault
tolerance.
ATA133 RAID Connectors
- You can connect a Master drive to each IDE RAID connector.
- The two connectors support hard disk drives only.
- For more information on ATA133 RAID, please refer to ATA133 RAID 0
or 1 Quick User's Guide.
MSI Reminds You...
If you install two hard disks on cable, you must configure the sec-
ond drive to Slave mode by setting its jumper. Refer to the hard
disk documentation supplied by hard disk vendors for jumper set-
ting instructions.
2-14
RAID IDE1
RAID IDE2
PRI IDE
Advertisement
Table of Contents
