MSI MS-9125 User Manual page 84

SCSI device to disconnect during an I/O transfer operation. The discon-
nection ability frees the SCSI bus to allow other I/O processes and thus
optimizes the SCSI bus performance. Setting options: Yes, No.
Send Start Unit Command
When set to Yes, the SCSI controller sends the Start Unit command to the
specified SCSI device during bootup. The interface powers up the SCSI
device on-at-a-time during bootup, reducing the load on the computer's
power supply. Setting options: Yes, No.
BIOS Multiple LUN Support
Select Yes when any SCSI device has multiple logical units. Setting
options: Yes, No.
Include in BIOS Scan
Selecting Yes allows the SCSI controller to control the SCSI device with
its SCSI ID. When set to No, the SCSI controller does not control the
specified SCSI device by not scanning for the SCSI ID during bootup,
but the boot time will be decreased. Setting options: Yes, No.
Advanced Configuration
Press <Enter> to enter the sub-menu screen for advanced configuration.
Advanced Configuration
Reset SCSI Bus at IC Initialization ................................................... Enabled
Display <Ctrl><A> Message During BIOS Initialization ............ Enabled
Extended Int 13 Translation for DOS Drives > 1 GByte .............. Enabled
POST Display Mode .......................................................................... Verbose
SCSI Controller Int 13 Support ........................................................ Enabled
Option Listed Below Has NO EFFECT if MULTI LUN Support is Disabled
Domain Validation ............................................................................ Enabled
Support Removable Disks Under Int 13 as Fixed Disks .............. Disabled
BIOS Support for Bootable CD-ROM .............................................. Enabled
Reset SCSI Bus at IC Initialization
Selecting Enabled will reset the SCSI bus the first time the SCSI controller
is initialized. Setting options: Enabled, Disabled.
SCSI BIOS Setup
4-7