Removing Convection And Speed Bake Motor Assemblies; Removing Oven Sensor - Electrolux NEXT GEN Service Manual

Three screws
4. Pull back on the assembly. Lift the rod and tip the
front of the assembly down to release the rod.
5. If replacing the assembly be sure to transfer the
spacing tab from old assembly to the new.
Spacing tab
Removing convection and speed bake motor
assembly:
1. Disconnect power and remove back panel.
2. Remove fan blade inside oven. (See fan blade
removal.)
3. Mark and remove the wires from motor assembly.
4. Remove the three screws holding the assembly to
the back of the range.
5. Pull the motor shaft out the back of the range.
6. The fan blade is spaced on the shaft by a C clip
and the cooling fan blade is held in place on the
shaft by a tennamen nut.
Three screws
C clip shown on shaft
Tennamen nut

Removing oven sensor:

1. Disconnect power and remove back panel.
2. Unplug wires to the sensor.
3. Remove the two screws holding the sensor to the
back of the range.
82