Section D - Disassembly And Replacement Of Parts; Backguard; To Remove The Backguard Back Panel; To Remove The Infinite Switches - Electrolux NEXT GEN Service Manual

SECTION D - DISASSEMBLY AND
REPLACEMENT OF PARTS
NOTE: To reinstall parts, reverse all procedures

Backguard

To remove the backguard back panel:

1. Disconnect power from range.
2. Remove six screws and lift the panel off.
Six backguard back panel screws
NOTE: Screws may be removed using either a 1/4" nut
driver or an S1 square drive.
Screw bits

To remove the infinite switches:

Infinite switches are used for the surface elements, warm
and serve zone, and the warming drawer (if equipped).
Backview of infinite switch
1. Disconnect power from the range.
2. Remove the back panel from the backguard.
3. Mark and disconnect the wires from the infinite
switch.
4. Remove the knob by pulling straight off.
Pull knob straight off
5. Remove the two phillips-head screws holding the
switch to the control panel.
Removing two screws
6. Pull the switch from the back of the range.
Electronic Surface Controls
To remove the potentiometer:
1. Disconnect power from the range.
2. Remove the back panel from the backguard.
3. Unplug the three pin plug from the
potentiometer.
69