Oven Vent (Smooth Top Models); Removing The Oven Light Cover (Self-Clean Models) - Electrolux NEXT GEN Service Manual

Oven vent (coil element models)

Oven vent (smooth top models):

1. Remove the backguard back panel and the range
back.
2. Remove the vent cover by removing three screws.
Vent cover on smooth top models
3. The oven vent is a two piece vent.
Oven vent pieces
4. To remove the back half of the vent pull straight back.
Backview of oven vent
5. To remove the complete vent. Remove the two
screws inside the oven holding the vent to the oven
liner and pull the vent out the back.
Inside oven vent screws
6. When installing the vent, slide the vent back in place
and install the cover. Tighten the screw in the cover
down, then loosen the screw in the center of the
vent cover. This will help align the vent to the
opening in the oven and make it easier to install the
screws inside the oven to the vent.

Removing the oven light cover (self-clean models):

1. Unsnap the spring loaded wire and pull the cover off.
Cover wire
80