Main Top Area; To Remove The Main Top With Coil Elements - Electrolux NEXT GEN Service Manual

7. Disconnect the wire tie from the rear of the main top
by squeezing the tabs of the rivet. Go to step 10.
Wire tie
Smooth top ranges:
8. Open the oven door and remove the two phillips
screws holding the main top to the front frame and
raise the main top.
9. Tag and disconnect all wires that come from the
backguard to the elements.
Smoothtop element wiring
10. Pull the wires and terminal blocks out the back
of the range and go to step 11.
Hole in splasher panel
11. Remove the three screws holding the oven vent cover
and remove the oven vent cover.
12 Remove the two screws holding the splasher panel
to the burner pan.
Two screws
Splasher panel screws

Main Top Area:

To remove the main top with coil elements:

1. Disconnect power from the range.
2. Remove the back panel from the backguard.
3. Remove the top elements, and unfasten the
terminal blocks from the main top by removing one
screw from each terminal block.
Terminal block screw
4. Remove the four hinge screws, two on each side.
73
Vent cover