Clutch Removal - Honda NSR150SP Manual

NSR150SP Clutch/Gearshift Linkage
/Kickstarter
_______________________________________________
DISASSEMBLY
Remove the oil pump.
Remove the water pump shaft.
Remove the tachometer drive gear.
Remove the clutch lifter piece by turning
the clutch lifter arm clockwise.
Remove the clutch lifter arm and spring.
INSPECTION
Check the dust seal fatigue or damage or
deterioration. Replace dust seal if
necessary.
Check the needle bearings for wear,
damage or loose fit. Replace needle
bearing if necessary.
NOTE
•
If the dust seal replacement is required, press
the dust seal to the case surface.
Check the clutch lifter arm for damage or bending.
Check the spring for fatigue or damage.
Replace these parts if necessary.
Apply grease to the clutch lifter arm sliding
surface.
Apply grease to the dust seal lips and needle
bearing.

CLUTCH REMOVAL

Remove the right crankcase cover.
Loosen the clutch lifter plate bolts in a
crisscross pattern in 2 or 3 steps.
Remove the lifter plate/bearing and clutch
springs.
10-6
http://mototh.com