Honda NSR150SP Manual page 74

NSR150SP
______________________________________________
Install the strainer joint to the oil tank.
Install the joint band.
Install the oil tank.
Install and tighten the bolts securely.
Connect the oil level sensor connectors.
Fill the oil tank with the recommended
engine oil and bleed the air from the oil
pump and oil line.
OIL TANK CAPACITY.
0.76 litre (0.83 US qt, 0.67imp qt)
RECOMMENDED ENGINE OIL:
Honda 2-stroke oil or equivalent
Make sure that there are no oil leaks.
OIL PUMP
CAUTION
•
Air in oil system will block or restrict oil
flow and may result in severe engine
damage.
•
Bleed air from the oil lines whenever the
oil lines, pump have been removed or
there is air in the oil line Bleed air from the
oil inlet line first, then bleed air from oil
outlet line.
NOTE
When removing and installing the oil pump, use
care not to allow dust or dirt to enter the engine.
REMOVAL
Remove the right side cowl and lower
cowl. (Page 2-4)
Drain the transmission oil.
Remove the bolts and oil pump cover.
(Page 3-14)
Remove the mount rubbers.
Disconnect the oil tube and oil pass
tube from the oil pump.
Lubrication System
4-4
http://mototh.com