Honda NSR150SP Manual page 65

NSR150SP
______________________________________________
BRAKE LIGHT SWITCH
CAUTION
•
Allowing the switch body to turn during adjustment
can break the wires in the switch.
NOTE
•
The brake light switch on the front brake lever cannot be
adjusted. If the front brake light switch actuation and
brake engagement are off, either replace the switch unit or
the malfunctioning parts of the system.
•
Make all rear brake light switch adjustments after the
height adjustment and the brake pedal free play
adjustment have been made.
Check the brake light switch operation and
adjustment by applying the brakes. Visually inspect for any damage and make sure
the reflector plate is clean within the light.
Adjust the rear brake light switch so that the brake light comes on just prior to the
brake actually being engaged. If the light fails to come on, adjust the switch so that
the light comes on at the proper time.
Turn the adjusting nut on the brake light switch and not the switch body and wires to
make switch actuation adjustments.
Be sure to hold the switch body firmly while turning the adjusting nut.
After adjustment, recheck to be sure the brake
light comes on at the proper time.
HEADLIGHT AIM
An improperly adjusted headlight may blind
oncoming drivers, or it may fail to light the
road for a safe distance.
NOTE
•
Adjust the headlight beam as specified by local laws and regulation.
Adjust the headlight beam by turning the screw at the under of the upper cowl.
CLUTCH SYSTEM
Measure the clutch free play at the end of
the clutch lever.
FREE PLAY: 10 - 20 mm 0.4 - 0.8 in)
3-23
http://mototh.com
Maintenance