NSR150SP
______________________________________________
SERVICE RULES
1.
Use genuine HONDA or HONDA-recommended parts and lubrications or their
equivalents. Parts that do not meet HONDA's design specifications may damage
the motorcycle.
2.
Use the special tools designed for this product.
3.
Use only metric tools when servicing this motorcycle. Metric bolts, nets and screws
are not interchangeable with English fasteners. The use of incorrect tools and
fasteners may damage the motorcycle.
4.
Install new gaskets, 0-rings, cotter pins, lock plates, etc. When reassembling.
4.
When tightening a series of bolts or nuts, begin with the larger-diameter of inner
bolts first, and tighten to specified torque diagonally, in incremental steps unless a
particular sequence is specified.
6.
Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces
before re-assembly.
7.
After assembly, check all parts for proper installation and operation.
8.
Route all electrical wires as shown on pages 1-22 through 1-27, Cable and
Harness Routing.
General Information
1-5
http://mototh.com