Honda NSR150SP Manual page 193

NSR150SP
________________________________________________
LEFT CRANKCASE BEARING
REPLACEMENT
Remove the crankshaft oil seal, balancer oil
seal, gearshift spindle oil seal and
countershaft oil seal.
Remove the balancer bearing and
countershaft bearing out of the left
crankcase.
Remove the mainshaft bearing out of the
left crankcase using special tools.
TOOLS..
Remover head, 16 mm
07936-MK50100
Remover shaft, 15 mm
07936-KC10100
Sliding weight
07741-0010201
Clean the crankcase with high flash point
solvent and check for crack or damage.
BALANCER BEARING
Apply transmission oil to the new needle
bearing.
Press the new needle bearing into the left
crankcase using the following special
tools.
TOOLS:
Driver
07749-0010000
Attachment 35 X 40 mm
07746-0010200
NOTE
• Install in the new needle bearing squarely with the marking side facing up.
Crankshaft/Transmission
12-12
http://mototh.com