Hitachi SJ7002 Series Instruction Manual page 212

Torque Limit
Signal
Opt. Code
[TRQ]
Symbol
[11 to [15],
Valid for
[ALx]
Outputs
B040... if
B040=00
Required
then set
Settings
B041, B042,
B043, B044
Default
Requires
config.
terminals
Run Time /
Power-On Time
Over Signals
11=[RNT]
Opt. Code
and
12=[ONT]
Symbol
[11 to [15],
Valid for
[ALx]
Outputs
Required
Settings
Default
Requires
config.
terminals
Clearwater Tech - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.clrwtr.com - Email: info@clrwtr.com
The Torque Limit output [TRQ] works in conjunction with the torque limit function covered in
the intelligent input section. The torque limit function limits the motor torque according to the
criteria selected by parameter B040. When torque limiting occurs, the [TRQ] output turns ON,
then turns OFF automatically when the output torque falls below the specified limits. Note that
10
the Torque Limit input [TL] must be ON in order to enable torque limiting and its related
output, [TRQ]. See
SJ700 Series inverters accumulate the total hours in Run Mode (run time) and the total hours
2
of power-ON time. You can set thresholds for these accumulating timers. Once the threshold is
exceeded, an output terminal will turn ON. One use of this is for preventative maintenance. A
signal light or audible alert could signal the need for servicing, calibration, etc.
Symbol
RNT Run Time Over
ONT Power-ON Time Over
B034
The two outputs [RNT] and [ONT] share the same time threshold parameter, B034. Typically,
you will use either the [RNT] or the [ONT] output only—not both at once. These outputs are
useful for the notification that a preventative maintenance interval has expired.
"Torque Limit" on page 4–30
Function Name
SJ700
2
in the intelligent input section.
Description
ON when the accumulated time spent in
Run Mode exceeds the limit (B034)
ON when the accumulated power-ON time
exceeds the limit (B034)
4–51
Inverter