CARBURETOR ASSEMBLY
Primary carburetor
1. Install:
•
Needle jet (1)
•
Connecter comp. (2)
NOTE:
Check that the connecter comp. (1) is in the posi-
tion shown in the figure.
2. Install:
•
Throttle valve
3. Install:
•
Spring
•
Throttle shaft
NOTE:
Assemble the spring as shown in the illustration.
4. Install:
•
Screw (connecter comp.)
NOTE:
Turn the throttle shaft clockwise (1/2 turn) to pre-
load the spring and then, holding it in position,
assemble the screw (connecter comp.).
Screw (connecter camp.):
2 Nm (0.2 mkg)
6-12
CARB