1
2
IGNICTION
NOTE:
Use the thin tester terminals to check continuity,
as the terminals might come into contact with oth-
ers inside the connector.
•
NOTE:
Check switch continuity various times.
5. Continue to check continuity between "R" and
3
6. If anything wrong is noted in any of the com-
7-7
SWITCH CHECK
Check continuity between "R" and "Br" at
switch positions ON (1), OFF (2) and PARK (3).
There must be continuity (ie the tester must
show "0") at ON and there must be no continu-
ity (ie the tester must show "∞" ) at OFF and
PARK. Something is not working between "R
and Br" if there is no continuity between these
two points at position ON, or if there is some
continuity in one of the other positions OFF or
PARK.
"L" and "L" and "Br" in the respective switch
positions in the manner described above.
binations, replace the switch component.
ELEC