5
4
3
1
2
5
4
1
4
6
1
2
~ 40 mm
4
3
2
3
~ 40 mm
FRONT FORK
12. The vice tightened, grip the outer tube and
with a few strong blows hit it against the tool
(3) until the DU outer tube bush (4) is correct-
ly positioned in its seat.
13. Remove the fork leg from the vice and remove
the tool (1). Insert the new washer (3) and the
new oil seal (4) as shown on the inner tube (2).
NOTE:
Apply lightweight lithium-soap base grease to the
oil seal before installing it.
14. Mount the tool (1) on the inner tube (2) with the
side (5) matching the oil seal (4) and clamp it
keeping the two joints (6) at the top and bot-
tom (never towards the jaws of the vice) and
make it protrude by at least 40 mm at the
sides.
DU bush/oil seal driver (1):
90890-11043
15. The vice tightened, grip the outer tube and
with a few strong blows hit it against the tool
(1). After each blow rotate the outer tube
slightly in order to install the oil seal (4) cor-
rectly and until it is completely inserted in its
seat.
4-54
CHAS