CLUTCH ADJUSTMENT
NOTE:
After adjustment, recheck lever free play to make
sure that it works smoothly and progressively.
If it is impossible to obtain the required adjust-
ment or if the clutch does not work properly,
adjust the internal mechanism.
Internal mechanism adjustment
1. Loosen:
•
Lock nuts on the lever cable adjuster and
crankcase adjuster
2. Fully tighten:
•
Adjusters
3. Drain off:
•
Engine oil
See section "ENGINE OIL REPLACE-
MENT".
4. Remove:
•
Footrest (right) (1)
•
Engine protector (2)
5. Disconnect:
•
Brake pedal return spring (3)
6. Remove:
•
Rear master cylinder fastening screws (4)
•
Oil delivery hose fastening screw (5)
•
Right crankcase cover fastening screws
•
Right crankcase cover (6)
7. Loosen:
•
Lock nut (1)
8. Push the engine clutch control lever forward
to the stop point.
9. Adjust:
•
Free play
With the lever in this position, turn the
adjuster (2) either way until the marks on
the lever (3) and crankcase (4) are
aligned.
10. Tighten:
•
Lock nut (1)
Lock nut:
8 Nm (0.8 mkg)
3-22
INSP
ADJ