2N NetSpeaker Manual page 26

SD card state – informs whether or not the SD card has been connected and is ok.
State – announces one of the following synchronisation states:
Synchronisation is not active
Waiting for synchronisation
Synchronisation in progress
Synchronisation error
Synchronisation completed
Ready for synchronisation
Calculation in progress
Synchronisation postponed
Sound settings
This section is devoted to loudspeaker sound parameters.
Volume and equaliser – use this parameter to set the loudspeaker volume.
This setting will not be active until saved. Use remote control or press the 2N®
NetSpeaker buttons or set volume for the whole zone to change the setting.
Detected parameters –
the server of the loudspeakers and power supplies connected.
Maximum gain – select a power supply and loudspeaker type to determine the
maximum gain.
Sound path delay – set the expected delay – buffer size – for 2N
NetSpeaker
Sampling frequency – set the audio signal sampling frequency.
Bits per sample – define the count of bits per audio signal sample.
Channels – define the count of audio signal channels – stereo/mono.
Bit stream – define the count of bits to be transmitted in 1s of audio signal.
Advanced settings
Disable multicast – disable multicast. Multicast is a Point–to–Multipoint
transmission option, which saves the network capacities (if implemented in
network elements) and server means.
Disable remote control – disable remote
Enable Telnet –
upon
even during
recommended for security reasons.
Activate relay during receving – select this option, for example, to switch
on/off the external amplifier if available.
Channel – set the
Button mode – select the HW button mode – channel switching or volume
setting. Or, deactivate the buttons.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
2N
for Wi–Fi installations or potentially unreliable packet deliveries.
Telnet connection is disabled by default for security reasons
®
2N NetSpeaker–server
®
2N NetSpeaker–server
®
2N NetSpeaker
®
NetSpeaker detects these parameters to inform
®
2N NetSpeaker
connection. Select this option to enable Telnet
connection. This option, however, is not
channel.
®
setting.
26