2N NetSpeaker Manual page 18

netmask
defaultgw
pwd
srvipaddr
srvport
srvpwd
Firmware upgrade
®
2N NetSpeaker
ets connected to the
devices have identical and latest firmware versions. Refer to www.2n.cz for the latest
firmware version.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Network mask for static IP address setting. Use this setting if dhcpclient is
set to 0.
Default setting: 255.255.255.0
Default gateway for packets routed outside the LAN. Use this setting if
dhcpclient is set to 0.
Default setting: 192.168.1.1
®
2N NetSpeaker's own password for authorising connection initiated by
®
the 2N NetSpeaker Server
®
2N NetSpeaker Server
NetSpeaker units in the system. This password is used for Telnet server
connection authorisation too.
Default setting: admin
®
2N NetSpeaker Server
i.e. if activemode=1.
Default setting: 192.168.1.1
®
2N NetSpeaker Server
active mode, i.e. if activemode=1.
Default setting: 6999
®
2N NetSpeaker Server
the active and passive modes of
®
identical with the 2N
Default setting: admin
firmware upgrade runs automatically whenever
®
2N NetSpeaker Server
. The same password must be stored in the
global settings and must be identical for all
IP address. Use the setting in the active mode,
communication port. Use the setting in the
connection authorisation password. Used both in
®
2N NetSpeaker
NetSpeaker Server password.
. This guarantees that all connected
2N
. The password must be
®
2N NetSpeaker
18
®
g