It is very easy to connect
avoid equipment damage or electrical injury:
1.
Connect a loudspeaker, headphones or an external amplifier.
2.
Connect the digital input and output.
3.
Insert the MicroSD card.
4.
Connect the UTP cable.
5.
Connect a 12V power supply (unless PoE is used).
Loudspeakers
Loudspeaker connection
®
2N
NetSpeaker
loudspeakers. The loudspeakers to be used must have the nominal impedance of
4–16Ohm. Possible configurations and related maximum power outputs (sinus, THD <
1%) are included in the table below:
Use the
channel and R + and R – for the right channel. Use the left channel terminals for the
MONO mode.
Headphone/External amplifier connection
®
2N
NetSpeaker
3.5mm jack is available on the front panel.
Digital Input and Output
®
2N
NetSpeaker
amplifier/alarm/activation. The
and allows for switching of up to 24V/1A AC/DC loads. Program the output either to the
N/O (normally open) or N/C (normally closed) mode.
Warning Do not exceed the upper voltage and current limits to avoid irreversible
damage of the equipment.
®
2N
NetSpeaker
movement or other applications. This input is available on the LOGIC IN terminal. Up to
5 to 24V DC voltage can be applied to the input against the ground terminal marked
DC IN –.
Warning Do not exceed the maximum voltage values (24V) applied to the LOGIC IN
input to avoid irreversible damage of the equipment.
Note
®
2N
TELEKOMUNIKACE a.s., www.2n.cz
2N
is equipped with a power amplifier for 1 (MONO) or 2 (STEREO)
Loudspeaker
2 x 4Ohm STEREO
2 x 8Ohm STEREO
2 x 16Ohm STEREO
4Ohm MONO
8Ohm MONO
®
2N
NetSpeaker
back panel terminals marked L + and L – for the left
is equipped with a headphone/external amplifier connector. The
is equipped with a relay switch for light signalling/external
is equipped with a digital
®
NetSpeaker
electrically. Follow the steps below to
12V/2A Supply
2 x 2.5W
2 x 7W
2 x 4W
1 x 14W
1 x 8W
output
is available on terminals marked LOGIC OUT
input
for an optional button, sensor of
PoE Supply
2 x 2.5W
2 x 4W
2 x 4W
1 x 8W
1 x 8W
14