2N NetSpeaker Manual page 13

LAN connection
Power amplifier
Headphone/Line output
Digital output
Digital input
Memory capacity extension
Caution: Be sure to connect the
same applies to PoE supply from the LAN.
Installation
If you intend to use your
four feet included in the delivery onto the bottom side of the device to avoid scratching
of the underlying surface.
Surface Mounting:
Use the included L–profiles to mount your
solid surface. Insert the L–profiles in the sides of the assembly and fit them with four
screws to keep the device in place. You can use the dowels and screws included in the
delivery. Follow the instructions below while drilling the mounting holes.
Electric Installation
Electric Installation Step by Step
®
2N TELEKOMUNIKACE a.s., www.2n.cz
RJ–45 connector on back
4 terminals on back panel
output
Frequency range
Harmonic distortion
Signal–to–noise ratio
5 to 24V DC digital input, galvanically non–isolated
Sound compression
Bandwidth
2N
panel
STEREO 3.5mm jack on front panel
24V 1A AC/DC relay output, galvanically isolated
MicroSD card slot on front panel
MPEG–2 Audio Layer III (MP3)
®
2N NetSpeaker
®
NetSpeaker unit in various interiors, please stick the
®
2N NetSpeaker
Figure: Mounting holes
TX with Auto–MDIX function
STEREO/MONO with auto
detection
20Hz – 20kHz (+/– 0.5dB)
0.05% @ 1kHz
91dB
32–320kbps
power supply as the last step. The
unit on a wall or another
13