2N NetSpeaker Manual page 17

List of parameters
activemode
searchmode
volume
domain
descr
dhcpclient: This parameter enables/disables automatic obtaining network
parameter settings from the DHCP server in the LAN.
ipaddr
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N NetSpeaker is connecting actively to the
Remember to set the srvipadr and srvport parameters correctly if 1 is
selected.
Setting options
®
2N NetSpeaker
0
®
2N NetSpeaker
1
Default setting: 1
®
2N NetSpeaker is searching for
and use Server's domain.
Setting options:
0
1
Default setting: 1
Settings of volume for
4096 is maximum.
Default setting: 1024
Settings of domain which is used by
Default setting:
Descr is voluntary parameter describing
use any string.
Default setting: MAC address
Setting options:
Automatic network parameter obtaining is disabled. Use manual
0
settings: ipaddr, netmask and defaultgw.
Automatic network parameter obtaining is enabled.
1
Default setting: 0
®
2N NetSpeaker static IP address. Use this setting if dhcpclient is set to
0.
Default setting: 192.168.1.100
passive mode. The server connection is initiated by
®
the 2N NetSpeaker Server
active mode. The server connection is initiated by
®
2N NetSpeaker
®
2N NetSpeaker Server
Searchmode is disabled
Searchmode is enabled
®
2N NetSpeaker where value 0 is minimum and
®
2N NetSpeaker
®
2N
®
2N NetSpeaker Server
.
.
in network
for communication.
NetSpeaker . It is possible to
.
17