Table of Contents
Advertisement
Install Jag
Engine
1.
Set the motor plate on the engine crankcase
and bolt in place. Tighten bolts to 7.6 kg-m or
55 ft-Ib.
Fig. 4-171
A033
4.
Tip snowmobile upright. Install the impulse
line on the crankcase fitting.
5.
Connect the electrical connector to the
engine connector plug.
~~
6.
Install the carburetor. Tighten the carburetor
clamp.
7.
Install the four nuts and washers that secure
the exhaust manifold in place.
8.
Install the drive belt; then secure clutch
guard.
9.
Connect the headlight wiring harness.
10. Install the recoil starter bolts. Pullout recoil
about
6 inches and tighten bolts to 0.69 kg-m
or 5
It-lb.
II
NOTE: Just before recoil bolts are tighten-
ed, pull the recoil so the starter pawls are
engaged. This will correctly center the recoil,
then tighten bolts.
2.
Guide rear motor mounts into the rear mount
holes in front end; then set engine onto front
motor mount studs and install nuts.
II
NOTE: Be sure to install any shims which
were removed during disassembly. Also be
sure that exhaust system bracket is in place.
3.
Tip snowmobile .onto MAG side and install
nuts on rear motor mounts. Tighten all motor
mount nuts to
2.9 - 3.6 kg-m or 21 - 26 ft-Ib.
Fig. 4-172
0725-066
64
Install Lynx
Engine
l
1.
Set the motor plate on the engine crankcase
and bolt in place. Tighten cap screws to 7.6
kg-m or 55
It-lb.
2.
Guide rear motor mount bracket into posi-
tion on the mount holes in front end; then set
engine onto front motor mounts and install
cap screws.
II
NOTE: Be sure to install any shims which
were removed during disassembly. Also be
sure that exhaust system bracket is in place.
3.
Tighten all motor mount cap screws.
4.
Install the impulse line on the crankcase
fitting.
Advertisement
Table of Contents
