Table of Contents
Advertisement
•
•
22. Place the woodruff key in the slot on the MAG
end of crankshaft.
23. Check the flywheel for any metallic particles.
Be sure magnets are clean. Install flywheel
over woodruff key; then install spacer.
Fig. 4-138
..
A015
24. Place the starter pulley in position and
secure with the three bolts and washers.
Install flywheel lock washer and nut.
Fig. 4-139
A114
25. Using a spanner wrench to hold the flywheel,
tighten the flywheel nutto 6.8 - 8.7 kg-m or49
- 63 ft-lb.
AB25F1
1.
Lubricate the crankshaft seals by applying a
liberal amount of grease between double lip
of the seal; then slide seals onto crankshaft.
II
NOTE: Make sure spring side of seal is
placed against bearing.
Fig. 4-140
A437
2.
Lubricate the connecting rod bearings and
the crankshaft bearings with oil.
3.
Apply a thin coat of crankcase sealer to both
halves of the crankcase. Always use a sealer
that remains pliable when dry (such as liquid
gasket or
RTV
silicone seal).
Fig. 4-141
A461
4.
Install crankshaft in bottom half of crank-
case. Be sure the alignment hole in each
bearing is positioned over the dowel pin in
the crankcase.
5.
If the bearings are not properly seated. the
crankcase halves will not bolt together
tightly.
Fig. 4-142
A431
55
Advertisement
Table of Contents
