Table of Contents
Advertisement
)
Choke Lever
Repair Kit
12. Place choke lever in console and secure with
knurled nut.
13. Check operation of choke lever.
l
210
Description
Weight
Jet Kit
Description
Weight
Jet Kit
(280
&
290 Main
Jet)
Qty.
Description
6
Weight
1
Jet Kit
(260
&
270 Main
Jet)
1
Jet Needle (6DH7-2)
Part No.
0146-105
6505-314
6505-215
Kit consists of:
Panther 5000, Cheetah 5000 0136-106
Part No.
Qty.
0146-106
6
6505-266
1
Kit consists of:
Pantera FA 0136-044
High Altitude
Kit
Part No.
Qty.
0146-108
6
6505-320
1
Kit consists of:
Pantera FC 0136-115
II
NOTE: E-ring on jet needle in carburetor
must be changed from fourth step to third
step.
To locate the high altitude kit for each model of
Arctic Cat snowmobile, refer to the accessory
chart on page 181.
Install spring on tee from kit and connect
choke cable.
Slide choke cable from the existing tee and
remove spring.
11. Connect choke cable assembly to carbure-
tor.
10. Place cover in the control box and secure.
9.
Place pin from the kit in the choke lever and
align with the hole in the tee. Using a hammer
and punch, gently tap pin until pin is flush
with lever.
7.
6.
8.
Place assembly in position in the control box.
Be sure choke cable is secured to tee.
5.
Separate halves of the choke control box.
4.
Using a punch and hammer, gently tap out
the pin securing the choke lever.
0115-149
Fig.
10·55
3.
Remove choke cable from carburetor.
2.
Slide choke lever through console.
1.
Remove knurled nut securing choke lever to
console.
To install the choke lever repair kit, use the
'ollowing procedure:
Equipment Necessary: Regular screwdriver,
hammer, punch
Pantera, Panther, Cheetah, Jag, Lynx 0136-104
t
:-1
i
~
' ji
~i
i
n
r
Advertisement
Table of Contents
