Table of Contents
Advertisement
·-----------~
27. Install the upper baseplate screw; then
tighten both screws.
A409
A408
29. Apply a small amount of Loc-Tite to the coil
ring screws and secure ring to the baseplate.
Tighten securely.
28. Position the coil ring against the baseplate.
Install the wire harness clamp and secure
with the mounting screw.
Fig. 4-111
Fig. 4-110
Fig. 4-112
1/
22. Using a fan holder, tighten the fan nut
securely.
A354
A410
26. Place the magneto baseplate in position
against the magneto case; then install the
lower screw only. Align the timing marks as
noted during disassembly.
Fig. 4-109
23. Install the fan protector and mounting
screws.
24. Move the magneto case into place on the-
MAG end of the crankcase.
25. Apply a liberal amount of Loc-Tite to each
screw before installing. Use an impact driver
to tighten the screws.
L
.
A407
30. Insert the woodruff key in the slot in the
crankshaft; then place flywheel in position.
Make sure the magnets are clean and free of
any foreign particles.
49
Advertisement
Table of Contents
