1.2
Connecting the Control Unit via terminals
1.2.1
Common information to the control terminals
Common information to the control terminals
To have access to the control terminals, the terminal cover must be removed, as shown in
the figure below. The control terminals have a maximum tighting torque of 0.25 Nm
(2.2 lbf.in) and a nominal cable cross section of 1.5 mm
Figure 1-3
The terminals of all variants of CU240 control units, once they have been wired, can be
individually detached from the control terminal board housing, as shown in the figure below.
This allows the control units to be swapped out for another of the same type without the
need for rewiring.
Control Units CU240S
Operating Instructions (Compact), 04/2006, A5E00766042B AA
Removing the Control Unit terminal cover
Installing/Mounting
1.1 Fitting the CU to the PM
.
2
1-3