Siemens SINAMICS CU240S DP-F Operating Instructions Manual page 90

Operation
3.3 Upload and download of parameter sets
Manual download
A manual download can be performed similar to an upload via
• PC (STARTER)
• MMC
• OP
It can be triggered - like upload - via
• PROFIBUS,
• OP
• STARTER
With a manual download a parameter set without the safety related parameters is
downloaded from one of the above mentioned devices into the inverter.
A detailed description is given in "Series Commissioning" in the commissioning section.
Automatic download
An automatic download needs a MMC to be performed. It is not possible to perform an
automatic download from a PC or from the OP.
The automatic download starts according to the settings in P8458 after power cycle or a after
a swap (see "Start-up behavior" in this section).
Contrary to a manual download even the safety parameters are downloaded with an
automatic download.
Note
Manual and automatic download
With a manual download all necessary parameters excluding the safety parameters (only
with fail-safe CUs) are downloaded into the inverter. A detailed description is given in "Series
Commissioning" in the commissioning section.
With an automatic download even the safety parameters are downloaded into the inverter.
An automatic download can only be performed with an MMC at Start-up or after a swapping
an inverter component (CU or PM). A detailed description is given in "Start-up behavior" of
this section.
3-10
Operating Instructions (Compact), 04/2006, A5E00766042B AA
Control Units CU240S