Fitting The Cu To The Pm - Siemens SINAMICS CU240S DP-F Operating Instructions Manual

Installing/Mounting

1.1 Fitting the CU to the PM

1.1 Fitting the CU to the PM
Fitting the Control Unit to the Power Module
The Control Unit is fitted to the Power Module as shown in the figure below. To disconnect
the CU push the release button on top of the PM.
The process of fitting the Control Unit to the Power Module is the same technique no matter
which Control Unit or Power Module combination is required.
Figure 1-2
Caution
Before snap-on the Control Unit to the Power Module while hot swap connect 24 V supply to
the terminals.
1-2
Fitting the Control Unit to the Power Module
Operating Instructions (Compact), 04/2006, A5E00766042B AA
Control Units CU240S