Connection Instructions - E-Mu Ultraproteus Operation Manual

MIDI Controller
(MIDI Keyboard, Sequencer, etc.)
Control
Pedal
E-MU SYSTEMS, INC.
Scotts Valley, California U.S.A.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
100-250VAC 50/60 Hz ~ THIS PRODUCT TO RAIN OR MOISTURE.
Male RCA plug
to
Male Phono Plug
Aux. or
Tape In
Home Stereo
System
MIDI In
UltraProteus is controlled by MIDI messages received at the MIDI In connector.
Connect the MIDI In of the UltraProteus to the MIDI Out connector of a MIDI
controller such as a MIDI keyboard, MIDI wind controller or MIDI guitar
controller.
Audio Outputs
UltraProteus is a high quality, stereo audio device. In order to reproduce its
wide dynamic range and frequency response, use a high quality amplification
and speaker system such as a keyboard amplifier or home stereo system. A
stereo setup is highly desirable because of the added realism of stereophonic
sound. Headphones can be used if an amplifier and speaker system is not
available. Plug stereo headphones into the headphone jack located on the left
side of the front panel. The Right Main output jack serves as a mono output
when the Left Main plug is not plugged in. The Left Main output jack serves as a
stereo output when the Right Main plug is not plugged in.
MIDI Out
MIDI
IN OUT THRU
To
Main Outs
SETUP #1 BASIC SETUP
The Headphone
Output is located
on the Front Panel
OUTPUTS
R - SUB2 - L R - SUB1 - L R - MAIN - L
MONO STEREO
Mixer
Amp
Speakers
Home Studio
System
Chapter 1: Basic Setup

CONNECTION INSTRUCTIONS

THE HEADPHONE OUTPUT
MONITORS THE MAIN
OUTPUTS ONLY. THE SUBMIX
OUTPUTS DO NOT FEED INTO
THE HEADPHONE OUTPUT.
IF ULTRAPROTEUS DOES NOT
SEEM TO BE RESPONDING
CORRECTLY, MAKE SURE THAT
BOTH ULTRAPROTEUS AND YOUR
MIDI CONTROLLER ARE SET TO
THE SAME MIDI CHANNEL.
MOST ULTRAPROTEUS FACTORY
PRESETS ARE PROGRAMMED TO
RESPOND TO PEDAL CONTROL.
SET YOUR KEYBOARD TO
TRANSMIT PEDAL ON
CONTROLLER #4, OR SEE "MIDI
REALTIME CONTROLLERS" IN THIS
MANUAL FOR ADDITIONAL
INFORMATION.
5