Cross-Switch Point; Primary Filter Type; Secondary Filter Type; Filter Level - E-Mu Ultraproteus Operation Manual

Cross-Switch Point

The Cross-Switch point determines the point at which cross-switching will
occur when key position or velocity is controlling Cross-Switch.
Velocity

Primary Filter Type

This screen allows you to select one of 288 Z-Plane filter types available in ROM.
These filters include: traditional low-pass filters, flanger simulators, vowel
formants, distortion filters, acoustic instrument models and many, many more.
See the reference section for a complete listing and descriptions of the filters.

Secondary Filter Type

This screen allows you to set the filter type for the secondary layer. See Primary
Filter Type.

Filter Level

This function sets the amount of signal into the filter. This control can be used
to balance the levels between instruments or to control the distortion charac-
teristics of the filter. Depending on the type of instrument and the filter, this
control can have a dramatic effect on the sound. This control differs from the
Volume parameter which adjusts the volume after the filter. The default setting
is 255 (full level).
XSWITCH POINT
064 (E3)
FILTER TYPE pri
F035 Ee-Yi.4
FILTER TYPE sec
F269 TensionWire
FILTER LEVEL
pri:198 sec:255
Key
Chapter 8: Preset Menu
PRESET MENU
IN ORDER TO CONTROL THE
CROSS-SWITCH FUNCTION,
YOU MUST ASSIGN
CROSSFADE TO A
MODULATION SOURCE IN
THE NOTE-ON OR REALTIME
CONTROL SCREENS.
UNDER CERTAIN UNUSUAL
CIRCUMSTANCES THE FILTERS
MAY OVERLOAD,
PRODUCING A LOUD
OBJECTIONABLE NOISE.
TURN DOWN THE FILTER
LEVEL VALUE TO ALLEVIATE
THE PROBLEM.
113