E-Mu Ultraproteus Operation Manual page 18

CONNECTIONS
8
Therefore, the Sub 1 and Sub 2 jacks can serve as effect sends and returns in
order to further process selected instruments and then return them to the main
mix.
The diagram shows the Sub 1 and Sub 2 jacks being used as send/returns in
order to further process selected UltraProteus presets without using the effects
bus on the mixing board. In a pinch, the effect returns could also be used to
sum additional instruments into the main outputs.
UltraProteus Output Section
R Bus
T i p Ti p
R in g
R L
S UB 2
The Sub 1 and Sub 2 jacks can be used as effect returns to the Main Outputs.
POWER UP!
The power switch is located on the right side of the front panel. UltraProteus
and its MIDI controller may be turned on in any order. When power is applied,
the liquid crystal display will light, indicating that UltraProteus is operating.
You may have noticed that there is no 110/220 Volt power selector switch on
UltraProteus.
UltraProteus automatically switches itself for 110 or 220 Volt
operation.
UltraProteus Operation Manual
L Bus
T i p Ti p
Ri ng R i ng
R L
S U B 1
T i p Ti p
R ing
R L
M AIN
R ing