E-Mu Ultraproteus Operation Manual page 142

For Velocity End & Key End
FUNC GEN
CondValue
FUNC GEN
CondValue
• When one segment jumps to another at a different level, a smooth transition
is made between the two. The time to the end of the destination segment
remains as specified.
1
In the example above, segment 4 has been skipped, but the time to the end of segment
5 will remain the same (400 milliseconds). This will alter the slope of segment 5.
Function Generator Amount
This control scales the output of the function generator before it is applied to a
modulation destination (in the Realtime Control screen). The amount is like a
water faucet. It controls "how much" of the function generator is output. If a
negative value is selected, the function generator output will be inverted.
Function generator 1 or 2 is selected on the top line of the display (F1 or F2).
When the value is Positive, a jump
F1S1
occurs if the velocity or key number is
+064
Greater than value shown.
When the value is Negative, a jump
F1S1
occurs if the velocity or key number is
-064
Less than value shown (ignoring the
sign).
3
2
4
Time = .4 sec
FUNC GEN AMT F1
+064
5
Time = .4 sec
Chapter 8: Preset Menu
PRESET MENU
DRAWING YOUR FUNCTION
GENERATOR IDEAS ON PAPER
FIRST WILL SIMPLIFY THE
PROGRAMMING PROCESS.
REMEMBER THAT YOU MUST
ASSIGN THE FUNCTION
GENERATOR TO A DESTINATION
IN THE REALTIME CONTROL
SCREEN.
THE FUNCTION GENERATOR
AMOUNT CAN ALSO BE
MODULATED BY A REALTIME
CONTROL SOURCE.
121