E-Mu Ultraproteus Operation Manual page 41

TO PROGRAM AN EFFECT:
1) Press the MIDIMAP button lighting the LED.
2) Slowly turn the data entry knob clockwise until you find the screen shown
below. Select one of the effect processors in the Mix Selection. This selects
the input to the effect processors.
3) Set the FX Amount for the A or B effect. This adjusts the ratio of effected to
un-effected signal. B->A allows you to route the output of effect B through
effect A (set the MIX to effect B).
A
B
4) Select the desired Effect and program the appropriate parameters.
5) Set the FX Output if you want to use the Sub 1 or Sub 2 outputs.
VOL PAN MIX C01
127 =P FXA
FX AMOUNT A:50%
B->A:0% B:50%
E FF ECTS AMOUNT
Wet/Dry Mix
sum
FXA
B A
Amo unt
F XB
Wet/Dry Mix
FXA:Echo
L Delay Time 255
sum
sum
Chapter 5: Effects Section
EFFECTS SECTION
THE DIAGRAM ON THE PREVIOUS
PAGE ILLUSTRATES THE
FUNCTION OF MIX SELECT.
SETTING THE B->A PERCENTAGE
TO MAXIMUM SELECTS "ONLY"
WHICH DISCONNECTS EFFECT B
FROM THE MAIN OUTPUTS AND
ROUTES ALL OF THE SIGNAL
THROUGH EFFECT A.
IF THE B->A AMOUNT IS SET
TO "ONLY", NO SOUND
WILL RESULT IF "NO
EFFECT" IS SELECTED FOR
EFFECT A
41