Advertisement
Setup
Connection Instructions
Connection
Instructions
Basic Setup
The headphone output
monitors the main outputs only.
The submix outputs do NOT
feed into the headphone output.
If Audity 2000 does not
seem to be responding correctly,
make sure that both Audity
2000 and your MIDI controller
are set to the same MIDI
channel.
14 E-MU Systems
MIDI Controller
(MIDI Keyboard, Sequencer, etc.)
MIDI Out
Control
Pedal
Male RCA plug
to
Male Phono Plug
Aux. or
Tape In
Home Stereo
System
MIDI In
Audity 2000 is controlled by MIDI messages received at the MIDI In
connector. Connect the MIDI In of the Audity 2000 to the MIDI Out
connector of a controller such as a MIDI keyboard, MIDI wind controller or
MIDI guitar controller.
Outputs
Audity 2000 is a high quality, stereo audio device. In order to reproduce its
wide dynamic range and frequency response, use a high quality amplifi-
cation and speaker system such as a keyboard amplifier or home stereo
system. A stereo setup is highly desirable because of the added realism of
stereophonic sound. Headphones can be used if an amplifier and speaker
system is not available. Plug stereo headphones into the headphone jack
located on the left side of the front panel. The Right Main output jack
serves as a mono output when the Left Main plug is not plugged in. The
S/PDIF output duplicates the function of the main output.
To
Main Outs
Amp
The Headphone
Output is located
on the Front Panel
Mixer
Speakers
Home Studio
System
Advertisement
