Hot Milk; Milk Foam; Dispensing Options; Stopping Continuous Dispensing - Schaerer Coffee Joy Operating Instructions Manual

www.schaerer.com
CAUTION!
Hot fluid!
CAUTION!
Hot fluid!
CAUTION!
Hot fluid!
18

Hot milk

Hot milk and milk foam are dispensed using the same button.
► Place a cup under the beverage outlet.
► Move the beverage outlet to the highest position.
 Air is always added to the milk unless the outlet is in the highest position.
► - Press the button (middle button).
 Hot milk is dispensed.
► Stop dispensing by pressing the
If dispensing is not stopped manually by pressing the
cally after a defined time period. This can be defined by the service technician.

Milk foam

Hot milk and milk foam are dispensed using the same button.
► Place a cup under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
► Press and hold the
 Dispensing takes place while the button is pressed.

Dispensing options

Stopping continuous dispensing

The dispensing of beverages and hot water can be stopped at any time.
► Press the button.
 The current dispensing process is stopped.

Selecting the coffee strength

Before dispensing, the coffee strength can be selected. The following strengths are available:
• Strong (ca. 15% stronger than the setting of the particular beverage)
• Normal (setting of the particular beverage)
• Mild (ca. 15% milder than the particular beverage)
If no preselection of the strength is made, the coffee strength is automatically set to "normal".
The selected strength always applies only to the next beverage.
► Use the button and the
► Place a cup under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
► Request the desired beverage.
 The beverage is dispensed.
 The beverage name and strength are shown in the display

Double beverage

Two beverages can be dispensed at the same time. This only applies to espresso, café creme
and cappuccino.
► Place two cups under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
► Press the required beverage button for ca. 3 sec.
 Only the symbol of the selected beverage appears; dispensing of the beverage begins.
 The display shows "2x beverage name".
button again.
button.
button to select the beverage strength.
Operation
button, dispensing ends automati-
BASCJ_EN
V01 | 02.2011