Front Wheel Hub - KYMCO Mongoose/KXR 250 Service Manual

14.
FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM

FRONT WHEEL HUB

REMOVAL AND INSPECTION
Place the machine on a level place.
Remove the front wheel ( 14-3) and
caliper. ( 13-8)
Elevate the front wheels by placing a
suitable stand under the frame.
Support the machine securely so
there is no danger of it falling over.
Remove the cotter pin.
Remove nut attaching the front wheel hub
and then remove front wheel hub.
DISASSEMBLY
Remove the outside collars.
Inspect the dust seals for wear or damage.
If any defects are found, replace the dust
seal with a new one.
Remove the dust seals by a flat-head screw
driver.
Place a wood block against the outer
edge to protect this edge.
Inspect the bearings for allow play in the
front wheel hub or the wheel turns roughly.
Nuts
Outside Collar
Outside Collar
Mongoose/KXR 250
Cotter Pin
Dust Seal
Dust Seal
Bearing
14-4