Rear Hydraulic Brake - KYMCO Mongoose/KXR 250 Service Manual

13
. BRAKE SYSTEM

REAR HYDRAULIC BRAKE

REAR BRAKE PADS REMOVAL
Remove the brake pads cover.
Remove the cotter pin and then pull out the
brake pad pin from the caliper.
Remove the brake spring plate and then
remove brake pads.
INSTALLATION
Reverse the "REAR BRAKE PADS
REMOVAL" procedures.
• Make sure put the spring plate big end
on the rear caliper.
• Make sure put the spring plate small
end on the rear pads.
• Make sure brake pad pin over the
spring plate.
BRAKE FLUID DRAINING
Place the machine on the level ground.
Remove the two screws attaching the brake
fluid reservoir cap (brake lever and brake
pedal).
Use shop towels to cover plastic parts
and coated surfaces to avoid damage
caused by splash of brake fluid.
13-11
Brake Pad Cover
Brake Pad Pin
Spring Plate
Spring Plate Big End
Brake Pad Pin
Spring Plate Small End
Reservoir (Front Left Lever)
Mongoose/KXR 250
Cotter Pin
Brake Pads
Reservoir Cover (Pedal)