Table of Contents
Advertisement
Installing the Wireless Transmitter
Utility
This section describes how to install the Wireless Transmitter
Utility. The Wireless Transmitter Utility is used to copy network
profiles to the camera and is required when configuring the
camera for connection to a computer in image transfer and
camera control modes (either the Wireless Transmitter Utility or
the camera menus can be used for connection to ftp servers in ftp
upload mode; see page 93 for information on using the camera
menus for ftp).
Follow the steps below to install the Wireless Transmitter Utility
under Windows 8.1, Windows 7, Windows Vista, or OS X.
❏ System Requirements
Before using the UT-1, WT-5, or the Wireless Transmitter Utility,
confirm that your system meets the following requirements.
Supported operating systems are listed on the Wireless
Transmitter Utility download site (013).
Camera
Power source
For information on whether more recent models
support the UT-1, see the camera manual. Be sure to
update to the latest versions of the UT-1 firmware and
Wireless Transmitter Utility.
One EN-EL15 rechargeable Li-ion battery or EP-5B
power connector and EH-5b AC adapter (available
separately)
11
Introduction
Advertisement
Table of Contents
