Troubleshooting - Nikon UT-1 User Manual

Troubleshooting

Problem
"POWER" LED does not
light.
Network option not
available.
Excessive radio
interference.
All LEDs flash at once.
Camera displays TCP/IP
or FTP error.
Camera displays wireless
error.
Camera displays
"Ethernet cable is not
connected".
Memory card error
displayed.
Transfer interrupted
before all photographs
are sent.
USB cable disconnected
during transmission.
112
Appendices
Solution
• Turn the UT-1 on.
• Confirm that the battery is
inserted and fully charged.
Confirm that the UT-1 is
connected and on.
Adjust the position of the wireless
access point or host computer.
UT-1 hardware or battery
malfunction. Contact a Nikon-
authorized service representative.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
• Check firewall settings.
• Confirm that host and wireless
LAN adapter are on.
• Ensure that there are no
obstacles between UT-1 and
wireless LAN adapter.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
Connect Ethernet cable or select
WT-5 (Wireless LAN) for Select
hardware.
Confirm that memory card is
properly inserted.
Transfer will resume if UT-1 is
turned off and then on again.
Reconnect the USB cable. Do not
turn the camera off.
Page
17, 25, 59, 65
9, 89
17, 25, 59, 65
—
—
15, 23, 57,
64, 84
8
—
—
23, 64, 84
16, 58, 81
—
17, 25, 59, 65
—