Table of Contents
Advertisement
A
Removing the Battery
Being careful not to drop the battery, open the
battery-chamber cover and remove the battery as
shown at right.
A
Stand-By Mode
When disconnected from the camera, the UT-1 will turn off automatically
after the delay chosen for Options > Auto power off delay in the
Network menu (089), reducing the drain on the battery.
A
Battery Level
The level of the battery inserted in the UT-1 can be determined by
connecting the UT-1 to the camera (04) and checking the battery level
using the Options > Battery info in the Network menu (089).
A
Using an AC Adapter
An optional EP-5B power connector and EH-5b or EH-5/EH-5a AC adapter
can also be used to power the camera when the UT-1 is connected. Insert
the power connector as shown below.
Open the UT-1 battery-chamber (qw) and power connector (e) covers
and then insert the EP-5B power connector in the orientation shown (r).
Position the power connector so that it passes through the power
connector slot (t) and close the battery-chamber cover.
10
Introduction
Advertisement
Table of Contents
