Installing Logs - Procom FBN280RHAC Series Owner's Operation And Installation Manual

INSTALLING LOGS

WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only parts
may result in property damage or
personal injury.
CAUTION: After installation and
periodically thereafter, check to en-
sure that no flame comes in
contact with any log. With the heater
set to High, check to see if flames
contact any log. If so, reposition logs
according to the log installation
instructions in this manual. Flames
contacting logs will create soot.
FIG(1)
1. All logs. See FIG(1).
FIG(3)
STEP 2:Install the log 2 on the right rear
iron. See FIG(3).
FIG(5)
STEP 4:Insert the pinhole on the upper
part on the left side of log 1. Place the
lower part of log 4 on the flat roof at the left
side of log 3. See FIG(5).
INSTALLATION
Continued
Figure 10 -Installing Log Set
IMPORTANT: Make sure log does not cover any burner ports (see
Figure 10).
It is very important. To install the logs exactly as instructed. Do not modify
logs. Only use logs supplied wall heater.
10
FIG(2)
STEP 1: Install the log 1on the left
rear angle iron. See FIG(2).
FIG(4)
STEP 3:Install the log 3 on the front
angle. See FIG(4).
FIG(6)
STEP 5:Insert the pinhole on the upper
part of log 5 in the pin on the log 2. Place
the lower part of log 5 on the flat roof at
the left side of log . See FIG(6).