Troubleshooting; Shut Off Gas Supply - Procom FBN280RHAC Series Owner's Operation And Installation Manual

Remote control fireplace; thermostat control fireplace
Table of Contents

Advertisement

WARNING: If you smell gas
l Shut off gas supply.
l Do not try to light any appliance.
l Do not touch any electrical switch; do not use any phone in your
building.
l Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
l If you cannot reach your gas supplier, call the fire department.
WARNING:Make sure that power
is turn off before proceeding....
OBSERVED PROBLEM
No spark when ignition button is
pressed.
Spark at ODS/pilot but no ignition
ODS/pilot lights but flame is continu-
ous igniting and the main burner
couldn't be lit.

TROUBLESHOOTING

WARNING: Turn off and let cool
before servicing. Only a qualified
service person should service and
repair fireplace.
POSSIBLE CAUSE
1. No power to heater
2. No battery in transmitter or battery
isn't correctly assembly
1. Gas supply turned off or equip-
ment shut off valve closed
2. Air in gas lines when installed.
3. Depleted gas supply
4. ODS/pilot is clogged
5. Gas regulator setting is not correct
6. Pilot electrude position is not
correct
7. W ire is not correct or loosen
8 Gas valve is damage
1. Thermocouple connection loose
at control board
2.
Pilot flame not touching
thermcouple which allows thermo-
couple to cool, causing pilot
flame to go out. This problem
could be caused by one or both of
the following
A) Low gas pressure
B) Dirty or partially clogged
ODS/ pilot
3. Thermocouple damaged
4. Control valve damaged
16
CAUTION: Never use a wire,
needle, or similar object to clean
ODS/pilot. This can damage ODS/
pilot unit.
REMEDY
1. Check the electric power
2. Place or replace the battery.
1. Turn on gas supply or open equip-
ment shutoff valve
2. Press ON/OFF button again
until air
is removed .
3. Contact
local
propane/LP gas
company
4
Clean ODS/pilot (see Cleaning
and Maintenance,page 13 ) or
replace ODS/pilot assembly
Replace gas control
5.
6. Replace Pilot
7. Check the wine and make wine
correct.
8. Contact dealer or procom.
1. Hand tighten until snug, then
tighten 1/4 turn more.
2. A) Contact local propane/LP gas
company.
B) Clean ODS/pilot (see Cleaning
and Maintenance, page 13) or
replace ODS/pilot assembly
3. Replace thermocouple
4. contact dealer or procom.

Advertisement

Table of Contents
loading

Table of Contents