Installing Transceivers And Module Connectors - Cisco Catalyst 6807-XL Hardware Installation Manual

Installing the Switch
• No parity
• 2 stop bits
Step 3 Connect to the port using the RJ-45-to-RJ-45 rollover cable and the RJ-45-to-DB-25 DCE adapter (labeled
Modem).
The console port mode switch should be in the IN position (factory default).
Step 4 Position the cable in the cable guide (if installed). Make sure there are no sharp bends in the cable.
Related Topics
Supervisor Engine, on page 3
Console Cables, on page 89

Installing Transceivers and Module Connectors

For detailed instructions about installing transceivers and module connectors, see the following:
•
•
•
Related Topics
Modules, on page 3
Pluggable Transceivers, on page 79
Module Connectors, on page 84
Cable Specifications, on page 88
OL-30656-01
Cisco SFP and SFP+ Transceiver Module Installation Notes
Cisco 10-Gigabit Ethernet X2 Transceiver Modules Installation Note
Installation Notes for the Cisco TwinGig and OneX Converter Modules

Installing Transceivers and Module Connectors

Cisco Catalyst 6807-XL Switch Hardware Installation Guide
47