Unpacking The Switch - Cisco Catalyst 6807-XL Hardware Installation Manual

Unpacking the Switch

• Rack-mount shelf kit—This kit is used to support the weight of the chassis while you secure the chassis
• Two 9-slot cable management guides—The cable guides can be installed on the front of the chassis
• Power supply and module blank panels—The power supply and module blank panels must be installed
• Right-angled grounding lug and disposable ESD wrist strap and clip.
• Screws
Related Topics
Rack-Mounting Guidelines, on page 24

Unpacking the Switch

Tip Do not discard the shipping container when you unpack the switch. Flatten the shipping cartons and store
them with the pallet. You will require these containers if you have to move or ship the switch in the future.
For repacking instructions, see
To check the contents of the shipping container, perform the following:
• Check the contents of the accessory kit. Verify that you have received all the listed equipment, including
• Check the modules in each slot. Ensure that the configuration matches the packing list and that all of
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
32
rack-mount screws. The clip nuts or cage nuts are not included as part of the accessory kit; you must
obtain them on your own.
L brackets to the rack enclosure. It consists of two shelf brackets and a crossbar bracket.
using the same sets of screws that secure the chassis rack-mount brackets to the rack posts.
on any unused power supply bays or module slots to maintain chassis airflow and EMI shielding.
Table 11: Types of Screws Shipped with the Accessory Kit
Type
12-24 x 0.75mm
10-32 x 0.75mm
M3 x 0.5 x 8mm
M4 x 8mm
Repacking the Switch, on page
any optional equipment you may have ordered, such as, network interface cables, transceivers, or special
connectors.
the specified interfaces are included.
Quantity
24
24
2
2
99.
Installing the Switch
OL-30656-01